FMF Racing® PowerBomb Stainless Steel Header 044262

Fits some Yamaha Raptor models. See below for full fitment information.

The redesigned PowerBomb is a four-stroke header that incorporates FMF's patented PowerBomb module at a precise location in the initial stage of the header. By positioning this "Bomb" at a key point in the system, increased performance and flow is achieved through the expansion and contraction of exhaust sonics through the system. Result is a flow increase of nearly 10%! The outer chamber in the Powerbomb allows the air to expand, cool and ramp back up at a higher velocity.

Additionally, the PowerBomb is a "pre-muffler" of sorts which helps to lower the bikes sound output by providing more sound absorbing surface area for the sound medium (exhaust gases). On some models, you can choose between a moto or supercross version. The supercross version is designed for more low to mid-range power where the moto version is focused in the mid to upper RPM range.

Features:

• Utilize FMF's patented module precisely located at the initial stage of the header
• Position "Bomb" increases performance; horsepower is increased as much as 10%
• Act as "pre-muffler" helping to lower the decibel output
• The expansion and contraction of exhaust sonics through the system causes increased flow

Finish:

• Stainless Steel

Fitment:

• 2011 Yamaha Raptor 250R 4x2
• 2008-2015 Yamaha Raptor 250 4x2
• 2008 Yamaha Raptor 250 SE 4x2 
• 2008 Yamaha Raptor 250 SE Custom 4x2