Tired of the same old tail lights? We’ve got the solution!
Solid billet BRASS “Titmouse” tail lights are not only built to last, but they’ll make your bike stand out from the crowd!
DON'T FORGET TO CHECK OUT OUR NEW MOUNTING OPTIONS!! (See Below)
- Tail Lights are CNC machined from a block of BRASS.
- Use with or without the stainless steel mesh screen to achieve the look you’re going for.
- Comes with a cluster of 16 extremely bright LED lights that won’t blow out due to vibrations like standard filament bulbs.
- Laser cut 11 gauge STEEL mounting plate included (Other mounting options available).
- Easy 3-wire install allows for brake and stop light operation.
- Made in the USA using domestic materials.
- Also available in ALUMINUM.
Finish:
- Brushed BRASS
Dimensions:
Tail Light:
- Length - 1-5/8”
- Diameter (Face) - 1-5/8”
- Diameter (Rear) - 1”
Mounting Bracket:
- Length - 3”
- Width - 3/4”
- Mounting Hole - ½”
Fitment:
- Any bike that accepts the above listed dimensions.
Mounting Options Explained:
***Each Titmouse Tail Light comes with the small mount shown in the first picture at no additional cost.***
***If you are purchasing a mount that accomodates two tail lights, you will have to click on the option for a second tail light to accomodate a Dual Mount. If you simply change the quantity, the entire order will be doubled and you will receive two tag mounts as well.***
"Sissy Bar" mounts are shipped flat and uncoated without any mounting tabs etc.
These mounts measure 8 inches long and are intended to be cut to length and welded to a sissy bar.
(This mount is intended to mount a tail light ONLY and does NOT accommodate a license plate.)
Tag Mounts (License Plate Holders):
"Fender Mount" kits are shipped flat and uncoated.
These mounts come with three mounting holes and are intended to be bolted to a rear fender.
"Standard" mounts are horizontal or vertical mounts that ship flat and uncoated without any mounting tabs etc.
These mounts are intended for use with a custom build.
"Shock Mount" kits are only available in vertical configurations and have a 7 gauge shock mount welded to back side of the plate bracket.
The 1/2"x1" slot accommodates just about any motorcycle shock set up out there up to a 3-1/2" diameter shock.
They come uncoated, ready for paint or powder coat.
"Frame Mount" kits are available in horizontal or vertical configurations and ship flat and uncoated.
These kits come with (2) Stainless Steel Socket Head Cap Screws, (2) counter-bored bungs, (2) threaded mounting tabs and (2) mounting brackets.
This kit will allow you to mount the License Plate bracket to just about any frame set-up.
We do not currently offer an axle-mount option, but we can custom fabricate one upon request for an additional cost.
